EMC QLogic Przewodnik Instalacji Pobierz pdf (Strona 30)

Installing and Configuring the QLogic HBA and v8.x-Series Driver

To stop the PowerPath service, issue one of the two following

commands:

etc/init.d/PowerPath stop

service PowerPath stop

5. If the QLogic SANsurfer daemon qlremote is installed and

enabled on the host, then the qlremote service must be stopped in

order for the driver to be removed from the currently running

kernel.

To stop the qlremote service, issue one of the two following

commands:

/etc/init.d/qlremote stop

service qlremote stop

Installing the QLogic v8.xx.xx Driver via the QLogic DKMS RPM: Method 1

This section guides you through the process of installing and utilizing

the DKMS RPM for Dell servers running the RHEL 4.0 distribution.

The DKMS RPM will build and install the QLogic driver modules

and will modify the /

etc/modprobe.conf file with the entries

similar to the following:

options qla2xxx ql2xfailover=0

alias scsi_hostadapter2 qla2100

alias scsi_hostadapter3 qla2200

alias scsi_hostadapter4 qla2300

alias scsi_hostadapter5 qla2322

alias scsi_hostadapter6 qla6312

The following are example steps to integrate the QLogic driver.

Please also refer to the README file in the driver package.

1. Boot into the qualified and supported kernel onto which the

driver will be installed.

2. Obtain the qla2xxx-v8.xx.xx1-2dkms.tgz package from the

EMC-approved section of the QLogic website as instructed under

the “Downloading the QLogic v8.x-series driver for the v2.6.x

kernel” on page 27.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 75 76

Brak uwag

EMC QLogic Przewodnik Instalacji Strona 30